it's not there
MFB POLYLITE, 4-voice dig/analogue Synthesizer unit with 3 Oszillators, 24 dB Filter, User RAM
Both main oscillators offer switchable square and saw tooth waveforms (the saw tooth was improved), as well as ring modulation for OSC 1 and an impulse waveform for OSC 2. In addition OSC 2 can be hard synced to OSC 1, too.
The octave range is switchable between 4’, 8’ and 16’ with an additional detuning range of plus minus one octave for OSC 2. The sub oscillator is fixed to 32’ and uses a square wave that can be controlled in level and fine tuning. The filter is an approved 24 dB low-pass design with resonance up to self-oscillation – its cutoff frequency can be modulated by different sources. VCF and VCA offer individual envelope generators with Attack, Decay, Sustain and Release parameters. Decay and Release either share a single control or, alternatively, Release may be switched off. Further modulations are performed by an LFO with One-Shot function. The LFO addresses oscillator pitch, pulse width or cutoff frequency.
Glides between legato played notes can be performed in three speeds.
MIDI-data processed are Note-On/Off, Pitch Wheel (plus minus 2 semitones), Mod-Wheel and additional Controller Data; Note Velocity can control the VCF as well as the VCA.
Preset programming is ideally performed from a MFB-SYNTH LITE II. A free Windows Editor software is ready for download here:
The MFB-POLYLITE’s dimensions are 175 x 125 x 35 mm, a power supply is included.
* 4 complete voices of MFB-SYNTH LITE II
* 2 saw tooth/square oscillators
* 1 square sub-oscillator
* ring modulation und oscillator sync
* 2 envelope generators (ADS/R)
* voltage controlled 24 dB low-pass filter
* 100 user memories
Read 1 comments
Add review/comment