Celestion 15" bass W-Bin design - Use MDF or ply - if you dont have a router to cut the guide grooves for the inner panels, then use batons as the plans say to keep them in place.
To build this you gotta build the middle bit on top of one side so to speak, then drop the other side on top - the inner chambers are held in place by the side panels in esssense... then add top/bottom/rear panels etc - line-up is important therefore and you need to dry-test fully and mirror the guides on either opposing panel.
Check it out, and good luck!
[plans will print out to an A4 page]
(very important to read this !!)
Good luck & happy building!
Read 18 comments
Add review/comment